Home Guide Protocols Lab

—

Lab checklist

Own gear, in order.

Twelve tasks. A TV, blank tags, a cheap remote you bought, a 3.3 V board, and a computer you admin. Progress stays in this browser.

Checklist

0/12 · 0%

Buy once, for this bench

microSD 8–32 GB, formatted FAT32
qFlipper from flipperzero.one/update
Notebook for IDs, pinout, never-list
NTAG213 or NTAG215 blank pack
Cheap 433/315 MHz remote + matching desk relay
3.3 V MCU (ESP32, Arduino, or similar)
Dupont jumper wires
EM4100 or T5577 blank, or a pet chip / fob you own
optional

Kit 0/8. Do not buy hotel encoders, car kits, or dumps.

Phase 0 · Bench

Card, firmware, and the rule you will keep repeating.

0/3

Mark Write the target list on paper done

Mark Seat a FAT32 microSD done

Mark Install official firmware via qFlipper done

Phase 1 · Light

IR on a display you own.

0/2

Mark Learn power and volume from your TV done

Mark Replay the saved remote across the room done

Phase 2 · Coils

LF RFID and NFC on media you bought or already own.

0/2

Mark Read an LF tag you own done

Mark Write an NDEF URL to a blank NTAG done

Phase 3 · ISM

Listen on Sub-GHz; replay only a static remote that is yours.

0/2

Mark Read RAW on an in-region ISM band done

Mark Replay a static remote that you own done

Phase 4 · Wires

GPIO voltage discipline and a serial console.

0/2

Mark Copy the official pinout into your notebook done

Mark USB–UART to a 3.3 V board you own done

Phase 5 · HID

DuckyScript on a computer you administer.

0/1

Mark Type a line into an editor on your PC done

Clears lessons, quizzes, kit, and this checklist in this browser.

Home
Guide
Protocols
Lab